fbpx

Rheem prestige series furnace error codes

Furnace0 comments

Rheem prestige series furnace error codes

Many people have experienced issues with their Rheem prestige series furnace error codes. Some examples of these errors are:

– Heat Pump Indicator Light On

– Power Supply Malfunction

– Thermostat Control Panel Error Codes

– Reset Control Board

An error code is an indication that the furnace needs repair. This article will list the Rheem Heating and Air Conditioning error codes for your future reference.

A1 Pilot Power is On, but Defrost Switch is Off. C18 Circuit Short/Open/Loss of Power to Receiver and or Tstat R230 High Limit Threshold Exceeded on Digital Controller F14 Fan Motor Stop Error H11 Overheat Error I1 Humidifier Flow Sensor Error or Water Tank Outlet Out of Service K2 Heating Motor Start Failure N2 Sensor Data Lost

N3 Sensor 2 Data Lost N4 Sensor 3 Data Lost O14 Overheat Control Limit Exceeded, Heat Pump Off O16 Auto-Off Sequence Failed to Operate O19 Cooling Valve Stuck Open P1 Communication with Remote Sensing Device Failed Q9 Heat Pump TC Operating Below

This article will discuss the error codes found on the Rheem prestige series furnace. The article will also compare some of the most common errors in other air conditioning models.

Simply because a boiler is going out of tune doesn’t mean it has to be replaced immediately. If you spot one of these error codes and are unsure what to do, then it would be best to consult a professional for assistance.

The article discusses all the error codes that can appear on the Rheem prestige series furnace and how they differ from other models to provide consumers with more information about their product.